|
We have over 30 years of
installation experience and use Schluter products for
all of our installations where possible. They are
designed to give you an easy to install complete
waterproofing system for the life of the project.
Schluter-Ditra
serves as an uncoupling layer, waterproofing membrane,
and vapor management layer that accommodates moisture
from beneath the tile covering. Further,
Ditra performs all these functions while still
providing adequate support/load distribution for the
tile covering. We also carry a full line of Schluter
products including:
Schluter-Kerdi
is a bonded waterproof membrane with limited
crack-bridging capabilities. It is made of soft
polyethylene, which is covered on both sides with a
special fleece webbing to anchor the membrane in the
thin-set mortar.
Schluter-Kerdi was developed as a waterproofing membrane
to be used in conjunction with ceramic and stone tile
coverings. Tiles can be installed directly on
Schluter-Kerdi using the thin-bed method. Other
trowel-applied covering materials, such as plaster, can
also be used.
Schluter-Troba
is a reliable and permanently effective drainage system
for use over sloped waterproofing layers. It consists of
a pressure-stable polyethylene sheet with perforated
studs that form vault like cavities between the
waterproofing layer and the mortar bed. Any water
penetrating the tile covering and the mortar bed passes
through the perforations located at the sides of the
trapezoid-shaped studs to the sloped waterproofing
layer, where it runs off freely through the cavities to
the drainage exit. |
A very good
installation video can be seen from the Schluter
Website
|
